Garage Floor Coatings.
Engineered, full-flake garage floors built into the slab, diamond-ground prep, 100% solids epoxy, and a UV-stable polyaspartic topcoat that takes hot tires, oil, and Florida heat without peeling. Real lifetime adhesion warranty.
A garage floor coating is only as good as the concrete it is bonded to, and that is where most garage floors fail. The cheap roll-on kits sold at hardware stores and the one-day crews that skip prep peel within a season because the coating sits on top of the slab instead of locking into it. Epoxy Guys have been coating Southwest Florida garages since 2012, over 2,000,000 square feet of flooring installed, and every garage we do starts the same way: full mechanical diamond grinding to open the concrete to a CSP-2 profile so the system bonds into the slab, not just onto it. That single difference is why our floors carry a real lifetime adhesion warranty and the kits do not.
Our standard garage build is a full broadcast flake system. After the grind, cracks are chased and filled, control joints are addressed, and the slab is moisture-tested. A 100% solids epoxy base coat is rolled and back-rolled into the prepared concrete, then vinyl flake is broadcast to refusal while the base is still wet so the chips lock into the resin. The next day the floor is scraped and vacuumed back to a uniform texture, and a UV-stable polyaspartic topcoat, one or two coats depending on use, seals everything in. The finished floor is roughly four times thicker than a single-coat kit, hides slab imperfections, and gives a subtle texture underfoot that stays slip-resistant even when wet from a rained-on vehicle.
In a Florida garage that matters more than most homeowners expect. Hot tire pickup, dropped tools, battery acid, brake fluid, road salt off a boat trailer, and afternoon slab temperatures that push past 100°F all attack a weak coating. A properly prepped flake-and-polyaspartic system shrugs all of it off and wipes clean with a mop. We install garage floor coatings for single and multi-car garages, workshops, collector and enthusiast garages, and detached shops throughout Naples, Marco Island, Bonita Springs, Estero, Fort Myers, Cape Coral, and the surrounding Collier and Lee County markets. Every project includes an on-site evaluation, a written scope, color-chip selection, and the same lifetime adhesion warranty that backs every Epoxy Guys system. Request a garage quote or call (239) 300-0546.
What a real garage floor gives you.
The difference between an engineered system and a weekend kit shows up by the second Florida summer.
- Hot-tire resistant. The polyaspartic topcoat won’t soften or lift when hot tires park on it, the failure mode that destroys most DIY garage coatings.
- Bonded into the slab. Diamond-ground CSP-2 prep plus 100% solids epoxy means it does not peel, bubble, or delaminate. Backed by a real lifetime adhesion warranty.
- Chemical proof. Oil, brake fluid, battery acid, antifreeze, gas, and pool chemicals wipe off instead of staining or etching.
- Slip-resistant. The broadcast flake gives a textured surface that keeps traction even when a vehicle drips rainwater across it.
- Seamless and easy to clean. No grout, no joints to trap dirt. A dust mop and occasional rinse is the entire maintenance routine.
- Hides slab flaws. The full flake build masks cracks, patches, and discoloration the bare concrete shows.
Garages we coat.
From a two-car attached garage to a detached enthusiast shop across Southwest Florida.
Single & Two-Car Garages
The most common job. A clean, sealed, easy-to-maintain floor that lifts the whole garage and the house value with it.
Three-Car & Oversized
Larger pours scheduled and prepped so the whole floor cures uniformly with no cold-joint lines.
Workshops & Hobby Shops
Bench areas, lifts, and tool storage. A floor that takes dropped steel and rolling jacks without chipping.
Collector & Enthusiast Garages
For owners who treat the garage like a room. Upgrade to metallic or custom flake blends for a show finish.
Detached Garages & Shops
Standalone structures, pole barns, and RV/boat bays that see trailers, salt, and heavy gear.
Re-Coat & Failed Floors
Stripping and re-prepping a peeling DIY kit or a failed contractor floor back to a system that actually holds.
How a garage install runs.
Most one and two-car garages are a one to two-day install plus cure. Prep is the part nobody else does right.
On-site evaluation
We inspect the slab, check for moisture and prior coatings, measure square footage, and walk color-chip options. You get a written scope and fixed quote, no surprises.
Diamond grinding
The whole floor is mechanically ground to a CSP-2 profile. This is the step DIY kits and one-day crews skip. It is the entire reason the floor bonds for life.
Repairs & crack chase
Cracks are chased out and filled, spalls patched, control joints treated, oil spots degreased. The slab is dialed in before any coating goes down.
Base coat & flake broadcast
100% solids epoxy base rolled into the slab, vinyl flake broadcast to refusal into the wet resin for full coverage and texture.
Scrape & polyaspartic topcoat
Excess flake scraped and vacuumed, then one to two UV-stable polyaspartic coats sealed over the top for the wear surface.
Cure & handover
Foot traffic at about 24 hours, vehicles after roughly 72 hours of cure. Walkthrough, care guide, and lifetime adhesion warranty handover.
Garage floor quotes.
Every quote is fixed to your slab condition and square footage. Your written quote breaks the system down line by line.
| Scope | Notes |
|---|---|
| Standard Flake System | Grind, base, full flake broadcast, single polyaspartic topcoat. |
| Heavy-Duty / Double Topcoat | Two polyaspartic coats, premium flake blends, workshop and high-traffic builds. |
| Prep-Heavy / Re-Coat Add | Stripping a failed coating, extensive crack/spall repair, or moisture mitigation. |
Garage floors we’ve coated.
Flake and solid-color garage floor systems installed across Naples and Southwest Florida.
Prep first, coating second. That order is why Epoxy Guys put a real lifetime adhesion warranty on this system and the hardware-store kits cannot.
Garage floor questions.
The ones that come up most on quotes. Ask us anything else.
Why not just use a hardware-store epoxy kit?
What is hot-tire pickup and does your floor stop it?
How long until I can drive on it?
Can you coat over a floor that’s already peeling?
Will it crack where my slab is cracked?
What colors and finishes can I choose?
What does the warranty cover?
Ready to talk
Coat Your Garage.
On-site evaluation with chip samples included, from Epoxy Guys. Fixed written quote, no surprises, no upsell on site.
Mon-Sat · 8a-6p · Naples, FL
EPOXY GUYS LLC
Over 2,000,000 square feet of floors installed across Southwest Florida since 2012 by a family-owned crew.
Services
Company
Get In Touch
4530 Arnold Ave #4 · Naples, FL 34104
Mon-Sat 8a-6p · Serving Collier & Lee Counties